Automate a work transfer proccess of pre-measuring, correcting, and final-measuring.
The tact time is 12.5sec with drill correction
Magneto Rotor, Planetary carrier, Compressor blade, etc.
2 station type (Left): Automate a work transfer process of pre-measuring and correcting.
3 station type (Right): Automate a work transfer process of pre-measuring, correcting, and final-measuring.
Upper: measuring station, Under: correcting and unloader station
Automate a work transfer process of pre-measuring, correcting, and final-measuring.
Automate a correcting process by twin-drill unit
Final measuring after correcting, and marking "OK" automatically.(3 station type)
|Journal diameter||ø19mm 1/5PT | ø25mm 1/5PT *Adapter can be replaced for various shaft diameter.|
|Mechanical unit||Bearing support system||Semi-Hard type *Calibration is necessary with test mass.|
|Chucking adapter||Taper chuck with key|
|Motor||AC servo motor, 0.75kW|
|Correction unit||Twin-drill unit|
|Carrying unit||Air cylinder|
|Unloader||Roller conveyor with air cylinder|
|Measuring unit||Balancing plane||1 plane|
|Measuring method||Fixed-speed method|
|Min. Achievable Unbalance||1.0µm（test piece mass: 3.0kg）|
|Min. unbalance indication||Correction: 0.01mg *selecting from mg, g, kg
Unbalance: 0.01mg•mm *selecting from mm,cm
|Indication mode||Polar coordinates and (3 to 24) components of unbalance vector
(add or remove of unbalance correction masses are selectable)
|No. of stored work data||50 data|
|Judgment of measured result||Judgment with set limit value|
|Graphic display||5.7" TFT color LCD with touch screen|
|Data transfer||Measured data can be transferred to PC by USB cable|
|Others||Environment||Temperature: 5 to 30°C, Humidity: 20 to 80％RH (Non-condensing)|
|Power supply||3 phase 200V ±10%|
|Dimensions||2 station: 1,250(W) x 1,300(L) × 1,960(H)mm
3 station: 1,710(W) × 1,300(L) × 1,950(H)mm
|Mass||2 station: 1,100kg
3 station: 1,700kg